Car, TOYOTA, HIGHLANDER , KLUGER, Blind spot monitor 1, A (BSM1)

Total distance traveled: 0

Total distance traveled: Km

Clear DTC

LED outer mirror indicator - voltage (currently value): 0.0 V

LED outer mirror indicator - current (currently value): 0 mA

Buzzer supply voltage: 0.0 V

Vehicle speed: 0.00 km/h

BSM main switch - operation count (data 1): 0

BSM main switch - operation count (data 2): 0

RCTA main switch - operation count (data 1): 0

RCTA main switch - operation count (data 2): 0

L-BSM - mode operation count: 0

Outer mirror indicator brightness setting - operation count: 0

RCTA buzzer volume level - operation count: 0

LED outer mirror indicator - current (dimmer OFF, bright): 0 mA

LED outer mirror indicator - current (dimmer OFF, dim): 0 mA

LED outer mirror indicator - current (dimmer ON, bright): 0 mA

LED outer mirror indicator - current (dimmer ON, dim): 0 mA

LED outer mirror indicator - blinking duty ratio: 0 %

RCTA buzzer sound - frequency: 1000 Hz

RCTA buzzer sound - duty ratio (large): 0 %

RCTA buzzer sound - duty ratio (middle): 0 %

RCTA buzzer sound - duty ratio (small): 0 %

Beam axis revision angle: 0.00 °

Power supply voltage: 0.00 V

Steering angle: 0.0 °

Yaw rate: -125.000 °/sec

VGRS - relative angle: 2.184 rad

Dimmer - signal: Off

Buzzer - sound: Off

Clearance warning buzzer - support: Not defined

FHL equipped information: Without

Rear traffic approaching indication - equipped information: Not support

Approaching vehicle support - equipped information: Not support

Parking BSM - equipped information: Without

RCTA equipped information: Without

Secondary collision brake (rear impacts while stopped) - equipped information: Not support

SEA function: Not support

Variable gear ratio steering (VGRS) ECU - equipped information: Without

DRS system: Without

Outer mirror type: Not defined

Left rear door type: Normal

Right rear door type: Normal

Passenger door type: Normal

Driver door type: Normal

Shift position R: Off

Turn signal switch: Off

Steering wheel - angle information: Pending

Axis adjustment - error code: 10

Software write status: After writing software

Rear side radar sensor - beam axis not adjusted: No

Rear side radar sensor - outside guaranteed operating voltage: No

Rear side radar sensor - outside guaranteed operating temperature: No

Rear side radar sensor - blockage: No

Rear side radar sensor - blockage level 2: No

Software not programmed: No

Module partial blockage: Without

Outer mirror indicator - brightness: Not defined

RCTA buzzer - volume: Not defined

L-BSM mode: Off

BSM alert options - setting: Indicator + Buzzer

Blind spot monitoring system: Valid

RCTA function: Valid

SEA function: Valid

Beam axis adjustment completion status: Completed

Destination information: Defined

Dealer radar emission stop mode: Off

BSM function - set invalid history: Not recorded

RCTA function - set invalid history: Not recorded

SEA function - set invalid history: Not recorded

RCTA buzzer