Bil, CITROEN, DISPATCH, JUMPY 3, 9HU (DV6UTED4) - EDC16C3

9HU (DV6UTED4) - EDC16C3 - 0

Identifikation

PSA reference: 96 53 95 89 80

ECU manufacturer: Bosch

Additional number: 96 64 35 69 80

Softwareversion: 04 01

Software reference: 65 67 40

Fejlkoder

P2144: Exhaust gas recirculation (EGR) valve - circuit short to ground

Controls

Clear DTC

Levende Data

Additional heater: Inaktiv

Inlet air temperature at manifold: 10.8 °C

Indlæringstilstand: Forkert; First EGR vlve programming correct; Last EGR butterfly programming correct; First EGR butterfly programming correct; Forkert; Forkert; ;

Barometrisk tryk føler: 0.976 bar

Turbo pressure: 0.988 bar

Brake pedal switch 1: Udløst

Brake pedal switch 2: Udløst

A/C authorisation: Nej

A/C thermostat: Lavt tryk

Køretøjets hastighed sensor: 0 km/h

Clutch pedal: Udløst

Gear engaged: Frigear

Brændstoftemperaturføler: 44.7 °C

A/C pressure sensor: 1.0 bar

Konfiguration: Korrekt

Motor kølevæske temperatur føler: 65.6 °C

Additive adding system fault:

Cooling fan relay: Inaktiv

Køleventilatorhastighed: 0.0 %

Cooling fan reference speed: 0.0 %

Batteri spænding: 14.46 V

Camshaft and crankshaft synchronization:

Fuel flow regulator: 19.6 %

Diesel output delivered by the pump reference value: 3184.3 mm³/s

Air flow volume: 23.5 kg/h

Motor status: Kører

Pre-post heating relay: Inaktiv

A/C cut-off request: Cut-off

Motor Hastighed: 803.1 Omdr.

Fuel pressure measured: 337.3 bar

Accelerator pedal position sensor: 0.0 %

Injected fuel quantity: 5.5 mg/impulse

Luft masse måler: 241.2 mg/impulse

Pre-injection advance 1: 19.1 °

Fuel injection advance (main): 0.7 °

Injector control error status: No fault

Turbo pressure: 1.012 bar

Reference fuel pressure: 345.1 bar

Turbo pressure duty cycle: 63.9 %

Bypass throttle solenoid valve open cycle ratio: 0.0 %

EGR throttle electrovalve open cycle ratio: 70.2 %

Intake air temperature sensor: 11 °C

Air flow reference for EGR: 235.5 mg/impulse

Immobilizer

Locking of the ECU: Låst

Statspærrestatus: Matched ECU

Problem detected when transmitting the unlock code: The programming status of the engine immobiliser cannot be read

Udgangs test

Controls

EGR throttle

Cooling fan high speed

Cooling fan low speed

Additional heating relay

EGR-ventil

Turbocharger control solenoid valve

Fuel flow regulator

Pre-post heating relay control

Additive pump

Muligheder

Controls

Diesel particulate filter replacement

Diesel particulate filter static regeneration

Diesel particulate filter dynamic regeneration

EGR valve change

Programming of the additive system if replacing parts (additive reservoir, pump or pipes)

Injectors replacement